Hardware & Pump Control
3 Pump Types
Support for DC peristaltic pumps, stepper motors with acceleration control, and on/off valves for pressure-fed systems.
40+ Pumps via I2C
Expand beyond 16 GPIO pins with MCP23017 and XL9535 I2C expander boards. Each board adds 16 channels.
Interactive Calibration
Built-in calibration wizard: set target volume, run the pump, measure actual output, auto-calculate correction factor.
Flow Rate Control
Configure precise flow rates per pump for accurate ml dispensing. Supports both time-based and step-based control.
Auto-Purge & Reverse
One-click reverse pumping for maintenance and tube cleaning. Bulk operations to purge all pumps at once.
Power Limit Management
Set maximum simultaneous pump power to prevent circuit overload. The system queues pumps automatically when limits are reached.
Real-Time Filling Gauges
Visual fill-level indicators on every pump card. Color-coded alerts: green, orange, red for at-a-glance status.
GPIO Polarity Config
Configure active HIGH or LOW polarity per board. Supports any relay module wiring without hardware changes.
Ready to Control Your Hardware?
From 6 pumps on Community to 40+ on Pro — start building today.